Rolls-Royce and Bentley Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4,278 Posts
The housing and shaft are integral and not separate. You can always check the Bentley Heritage site and look at the parts diagrams. From an engineering point of view, you would not want this as 2 pieces due to the nature of the part. If you look inside the housing you will most likely see the center line where it was finished on a lathe after casting.Make sure your belleville washers go in the proper way.
 

·
Registered
Joined
·
4,278 Posts
Also,remember to fill the trunnion with 150 ml of fluid before install. It's a lot easier when removed.
 
1 - 2 of 2 Posts
Top