Rolls-Royce and Bentley Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Current Era 2003-present
    Hello everyone, Today we prepared an article about how we replace stock Bentley Flying Spur Third generation brake systems with Carbon-Ceramic brake solution. This car was assembled in 3 trim levels with engines: 6.0 liter V12 twin-turbo, 4.0 liter V8 twin-turbo, and 2.9 liter V6 twin-turbo...
  2. Current Era 2003-present
    Hello, everyone. This is the second part of the Carbon-Ceramic brake system installation progress on Rolls-Royce Cullinan. In this article, we will look at how the end runout test of the brake rotors was carried out, installing the front 10-piston calipers and 4-piston calipers on the rear axle...
  3. Current Era 2003-present
    Hello, In this article, we'll take a detailed look at installing a carbon-ceramic brake system on a Rolls Royce Cullinan. First of all, the car was raised on a lift, and the wheels were removed from it, the stock brake system was cleaned of brake fluid and removed from the car. In stock were...
  4. SZ Motorcars 1980-2003
    Hello. I want to know what's the correct power steering and brake fluid to buy for a 1989 Corniche 2. I want to make sure so I don't accidentally end up buying the wrong one. Thanks.
  5. Current Era 2003-present
    While going over bumps or rough road or when lightly touching the brakes they have a clicking noise. It's not too loud but is annoying. Bentley has no solution. I discovered that the back of the pads, the side that is against the pistons are very very sticky. I think they are designed to stick...
  6. SZ Motorcars 1980-2003
    Good Morning All, A few weeks ago I purchased a 1991 silver spur ll. When I purchased it, the large brake (mineral fluid) reservoir had a slight leak in it. The brakes also had a lot of air in the lines. I purchased the hydraulic fluid reservoirs and was finally able to replace them this...
  7. SY Series I and II 1965-1980
    Has anyone successfully replaced the rubber boots on the rear parking brake cables without replacing the whole cable? I’m wondering if I were to find the correct size boot if I could get it to stretch over the cable end without tearing.
1-7 of 7 Results
Top